Sticker Burr Roller · Push 1.0 and 2.0

10 steps. No tools. About 15 minutes.

Do not cut the black foam. Cut tape and cardboard only.

Call the Utah shop · (435) 632-4441

Check the box before you start

All 11 parts

1 · Lower frame, bent tube

2 · Lower frame, U tube

3 · Upright tube

4 · Foam roller

5 · Conveyor screen (mesh)

6 · White PVC tube

7 · Upper handle tube

8 · U bracket

9 · Handle bar

10 · Side rods (pair)

11 · Catch basket

1. Build the roller core

Uses parts 1, 2, 3 and 4.

Parts needed:

1. Connect part 1 to part 2 (lower frame).
2. Add the upright tube, part 3, to that build.
3. Slide the foam roller, part 4, onto the frame.

2. Install the screen and PVC

Adds parts 5 and 6 to your roller core.

Parts needed:

1. Fit the conveyor screen, part 5, down over the roller core.
2. Add the white PVC tube, part 6.

TipPull the screen all the way down over the foam.

NotePart 6 is the white PVC tube from your parts check.

3. Join the frame

Adds parts 7 and 8, then joins the two halves.

Parts needed:

1. Connect the upper handle, part 7, to the U bracket, part 8.
2. Join that build to your roller core. Push every joint fully in.
3. Rotate the whole unit upright.

TipPush every joint fully in before moving on.

NoteRotate the unit upright after this step, as shown in the booklet.

4. Assemble the handle

Adds parts 9 and 10 to your standing build.

Parts needed:

1. Connect the handle bar, part 9, to the two side rods, part 10.
2. Join the handle to the frame. Push both rods in evenly, one on each side.

TipPush both rods in evenly, one on each side.

NotePart 10 is a pair — one rod per side, they are not interchangeable ends.

5. Install the catch basket

The last part. Fit 11 and the build is finished.

Parts needed:

1. Fit the catch basket, part 11, onto the frame. You are ready to roll.

TipEmpty the catch basket when it fills up.

NoteCheck every joint is locked before first use.

Open the full photo booklet →

First roll

• It will not pick green burrs still on the plant. Cut or mow first, then roll the loose seed, 2 to 3 passes.
• Plan on 2 to 3 passes over the same patch.
• Lightly rake if seed is buried in grass.
• On grass or hard soil, strap ordinary ankle weights to the side bars, up to 10 lb per side. The roller is light so it will not sink in sand.
• Empty the catch basket whenever it fills.
• If the mesh clumps on one side, pull the screen down evenly over the foam and start again.

Questions or a missing part:
(435) 632-4441
customersupport@stickerburrroller.com